Reverse Incremental Cutting Finger Tips for Granite

Wet / Reverse M12 thread / For hard granite / For radial arm machines

Professional Reverse Incremental Cutting Finger Tips for Hard Granite

Hard granite fabrication on radial arm machines requires an incremental finger tip that can maintain controlled cutting performance while matching reverse-thread machine setups.

DIATOP Reverse Incremental Cutting Finger Tips for Granite are designed for wet cutting and use a reverse-direction M12 thread.

The tools are suitable for hard granite and are specified for use with Sasso K600, Coblam, Donatoni Jet 625, and Port saber machines.

Type of Equipment: RA (Radial Arm Polisher)

Key Features

• Reverse direction M12 thread.

• Suitable for hard granite.

• Designed for wet cutting.

• Suitable for Sasso K600.

• Suitable for Coblam.

• Suitable for Donatoni Jet 625.

• Suitable for Port saber.

• Available in 16 mm and 20 mm diameters.

Available Sizes

Item – Diameter inch / Diameter mm / Height mm

• RIFG1620 – 5/8 inch / 16 mm / 20 mm

• RIFG2020 – 3/4 inch / 20 mm / 20 mm

* Reverse M12 thread.

Operation Parameters

• RPM: 4500

• Feed: 400–1000 mm/min

Technical Notes

• Tool Type: Reverse incremental cutting finger tip

• Wet cutting

• Thread: Reverse M12

• Diameter options: 16 mm, 20 mm

• Height: 20 mm

• Recommended RPM: 4500

• Recommended Feed: 400–1000 mm/min

• Suitable Material: Hard granite

• Machine compatibility: Sasso K600, Coblam, Donatoni Jet 625, Port saber

Typical Applications

hard granite incremental cutting, reverse incremental cutting, granite sink cutout, granite countertop fabrication, radial arm stone cutting, Sasso K600 cutting, Coblam cutting, Donatoni Jet 625 cutting, Port saber cutting, wet granite cutting, stone fabrication

Q1. What reverse incremental finger tip is recommended for hard granite?

A. DIATOP Reverse Incremental Cutting Finger Tips for Granite are designed for wet cutting of hard granite and use a reverse-direction M12 thread.

Q2. What machines are compatible with the Reverse Incremental Cutting Finger Tip for Granite?

A. The catalog specifically lists Sasso K600, Coblam, Donatoni Jet 625, and Port saber.

Q3. What operating parameters are recommended?

A. The catalog specifies 4500 RPM and a feed rate of 400–1000 mm/min.

For reverse incremental finger tip selection guidelines, machine compatibility, reverse-thread setup, operating parameters, and troubleshooting guidance, please visit the DIATOP Tech Notes section.